Description
New Triple 4.2 Amp Dual USB Charger + Blue Voltmeter +12 Volt Socket Panel Jumpers #fs15/qcn/cwa/cvmb/cr/q/4#
This listing is for a voltmeter, dual powerful 4.2 amp USB charger, 12 volt accessory socket, triple mounting plate, mounting screws rubber mounting sealing washers, a daisy chain interconnect jumper and fuse holder with fuse. #fs15/qcn/cwa/cvmb/cr/q/4#
Rubber washer acts as a locking washer to prevent the nut from coming loose in high vibration installations.
Ships from the USA.
Marine Grade 12 Volt Power Socket
For Motorbike Car/Boat/ATV/UTV/Camper/Caravans/ Travel Trailer etc
Specifically designed for marine and motorcycle applications
UV stabilized nylon housing with rubber splash proof tight fitting front cap
2 pole nickel plated brass terminal connectors. 0.250 male spade type.
Twist-and-Lock locking socket, allows a suitable power plug (not included) to lock into place. Works wth all 12 volt accessory plugs.
Rated for 15 amps at 12 volts peak 20 amps. draws no power when not in uses.
Dual USB Charger
Comes with front cap and heavy duty construction.
Blue LED power on indicator UV Nylon Body.
Suitable for interior or exterior use.
Suitable for charging GPS, iPhone, iPod, Mobile Phones and other digital devices
Specification:
2 port USB Socket
Waterproof Design
Power Input: DC 12V-24V
Output: 5V 4.2 A DC.
Waterproof USB Cap
Rubber sealing washers make the assembly vibration resistant and waterproof mount.
DC Voltmeter
Blue Display: segment LED digital tube, lamp display is blue.
Monitors the state of your battery between full charged and discharged
Can indicate a poor or bad charging system. Tells whether your battery is holding a charge or not
The meter has easy to read LED segments and connect to your 12 volt system.
The meter draws nominally 10 ma. and the range is to 35 vdc
The two daisy chain jumper allows you to connect up all three devices and make one connection to your 12 volt source.
The triple plate
The three devices mount in individual 1-1/8″ holes, in panels of unlimited thickness, an optional nylon retaining nut can be used to holds the devices in place on panels of less than 1-1/2″ thick.
The mounting plate fits over the front of the devices to hold them against panel or dashboard. Held in place by four black screws included.
