Description
Sump Pump Alarm 12 Volt Battery Monitor For Low Voltage Discharge State or Capacity #BA3E
Prevents dead batteries when in storage, when the charging source has failed or end of life. Waterproof enclosure with 15 ft fused power cable with alligator clips.
The alarm will sound if your battery becomes discharged to the level at which it must be charged or is becoming dangerously low.
Avoid dead battery due prolonged use, due to power failure, charger failure. Lets you know when battery must be charged. #BA3E
Works with all kinds of 12 volt batteries.
For all kinds of storage batteries- Deep Cycle Lead Acid, Gel Cell, AGM.
Ideal for sump pump batteries that are in prolonged use, or with 12 volt battery being stored for a prolonged period.
Use this with your battery charger to alert you to a power failure. This will tell you when your battery must be charged at the 50% 12 volt level.
This device goes across your battery and attaches to the battery terminal with a 20 foot fused cable. If your battery gets discharged below 12 volts ( factory adjustable (10-14V) the alarm will sound and a red LED will glow. This allows you to know when you must begin recharging your battery before the discharge becomes excessive and permanent loss of battery life occurs. Alligator clips allow you to attach this to any 12 volt battery.
Ideal for Motorcycles, Cars in storage, Snowmobiles, ATV, Boat batteries, Generator starting batteries, RV battery banks, Sump pumps, well pumps, sewage discharge pumps and bilge pumps.
This listing is for one (1) battery monitor with alarm and LED and 15 foot fused cable. Has a fused harness that attaches to the battery terminal lugs with alligator clips. Place the alligator clips on the battery lugs. When the battery voltage drops below 12 volts the alarm and LED will be active. The alarm is a 80 db tonal alarm at 3000 hz. Operate down to 8 volts and up to 15 volts. Do not exceed 16 volts.
