Description
AGM Battery Low Voltage Detector Alarm 12V Monitors Discharge #CBA7A/sw-AGM
For AGM batteries Prevents dead batteries, Measure voltage tells you when to charge your battery. Works with all batteries. Loud high pitched pulsating alarm with flashing red LED indicators.
AGM battery life is measured in charge cyles. While AGM batteries can be discharged to greater levels below lead acid flood cell bateries, if the discharge level goes below a ceratin a certain point ( see chart) the cycle life of the battery will be reduced. To get maximum battery life and extend the life of the battery, this alarm will alert you to when the battery should be recharged.
Great for batteries on vehicles being stored. Trolling motors in use. Battery banks.
The alarm will sound if your battery becomes discharged to the level at which it must be charged. Allowing batteries to become too discharged shortens the battery life
Avoid dead battery due prolonged use, storage or charger/power failure. Lets you know when battery must be charged. #BA7a/sw-AGM
Use this with your battery charger to alert you to a power failure. This will tell you when your battery or battery bank must be charged.
This device is connected to your battery and attaches to the battery terminal with a fused cable.. If your AGM battery gets discharged below 11.8 volts the alarm will sound and a red LED will glow. This allows you to know when you must begin recharging your battery before the discharge becomes excessive and permanent loss of battery life will occur.
Ideal for Motorcycles, Cars in storage, Snowmobiles, ATV, Boat / marine battery bank, Tractor batteries, Snowblower, Lawn mower or Generator starting batteries, RV battery banks, solar battery storage installatios.
This listing is for one (1) AGM battery monitor with alarm and LED, rubber mounting washer. When the battery voltage drops below 11.8 volts the alarm and LED will be active. The alarm is a 80 db tonal alarm at 3000 hz. Operate down to 8 volts and up to 15 volts. The alarm voltage level is set at the factory using calibrated power supplies. Custom set levels are available upon request, prior to purchase. Maximum voltage level 16.0V.
Mounts in a hole 1-1/8″ in panels up to 1-1/2″ thick. Various panel and exterior mounts are available at our other listings.
