Description
Fused Triple Fast Smart 4.2 Amp USB Charger + Voltmeter +12V Socket Panel Marine #FS15/QCN/CR/CVB/CWB/Qplt/#
Now with interconnecting daisy chain jumper wires, waterproof fuse holder and rubber mounting washers.
This listing is for a Voltmeter, Smart 4.2 Amp dual USB charger, 12 volt accessory socket, triple mounting plate with mounting screws and a fuse holder with fuse. #FS15/QCN/CR/CVB/CWB/Qplt/3sw/4sq
Ships from the USA.
Marine Grade 12 Volt Power Socket
For Motorbike Car/Boat/ATV/UTV/Camper/Caravans/ Travel Trailer etc
Specifically designed for marine and motorcycle applications
UV stabilized nylon housing with rubber splash proof tight fitting front cap
2 pole nickel plated brass terminal connectors. 0.250 male spade type.
Twist-and-Lock locking socket, allows a suitable power plug (not included) to lock into place. Works wth all 12 volt accessory plugs.
Rated for 15 amps at 12 volts peak 20 amps. draws no power when not in uses.
Dual USB Charger
Comes with front cap and heavy duty construction.
UV Nylon Body.
Suitable for interior or exterior use.
Suitable for charging GPS, IPhone, IPod, Mobile Phones and other digital devices
New Smart 4.2 amp charger, 4.8 amps peak. This Charger has distributed power intelligence. The power is distributed between the two ports on demand and as required by the device being charged up to 3.3 amps per port. As your device gets charged the current demand from the charger tapers off. Say you have one device plugged in that is mostly charged and one device that is fully discharged. The device that is almost charged may only be drawing 1 amp from the charger. While the initial demand of the device needing to charged my be 3 amps. The charger will distribute the power accordingly. If you plug two fully discharged device in the charger will provide up to 2.1 amps per port to begin the charging cycle.
DC Voltmeter – Large body
Display: segment LED digital tube, lamp display is blue.
Monitors the state of your battery between full charged and discharged
Can indicate a poor or bad charging system. Tells whether your battery is holding a charge or not
The meter has easy to read LED segments and connect to your 12 volt system.
The meter draws nominally 10 ma. and the range is 5-35 vdc
The triple plate and mounting washers.
Rubber mounting washer go between the components and the mounting surface as shown in the assembly drawing to make a vibration proof and water tight seal.
The three devices mount in individual 1-1/8″ holes, in panels of unlimited thickness, an optional nylon retaining nut can be used to holds the devices in place on panels of less than 1-1/2″ thick. See Drilling template for mounting dimensions.
The mounting plate may differ from what is shown and allows for the assembly to be mounted in 1-1/8″ holes with or without the backing nut. The plate fits over the front of the devices to hold the elements against panel or dashboard. Held in place by four black screws included. If the backing nut is used to secure the elements to the panel/ dash then the plate is merely decorative.
