Description
Panel Fused Battery Bank Monitor Minder Low Voltage Discharge Alarm 12V Sailboat #BTM3F
Monitor your battery or battery bank for a low voltage discharge condition.
Fully wired 12 volt fused battery monitor panel. Alarms when battery voltage drops to the minimum voltage level, when the battery must be charged. The built in voltmeter indicates the voltage level. The built in high pitch tonal 80 db alarm and blinking warning LED alerts you to the low battery condition. A three position switch allows you to turn off the alarm. The switch has two alarm monitoring positions; one with the voltmeter display on and one position without the voltmeter display for low current monitoring. Center position of the switch is all off. Also included a panel mounted fuse holder with fuse. Comes with a waterproof 72″cables and female terminals. The panel is splash proof from the front. Red alarm and voltmeter, also available in blue upon request. #BTM3F
This pre-wired assembly consists of a built in battery voltage monitoring circuit board, a high quality voltmeter for checking the voltage level of your battery, built in tonal alarm and blinking red indicator, and a three position waterproof switch to control the panel.
The panel monitors your battery when the voltage drops to 12 volts the alarm goes off telling you to charge your battery before permanent damage is done to your battery in the low discharge state.
Voltmeter
The meters have easy to read red LED segments and connect to your 12 volt battery. The meter front is splash proof. The meter draws nominally 10 ma. and the range is 5-35 vdc.
Alarm
High volume notification tonal alarm with a bright blinking red LED draws 10 ma when in the alarm condition.
Switch
Three position switch. Center off draws no power. Monitor position I Monitors only and draws minimal power. When a low voltage condition occurs the alarm will sound. Monitor position II has the voltmeter active and monitors the battery.
Fuse Holder
Panel mount fuse holder with glass fuse. Splash proof easy fuse access.
Mounting and installation
The mounting plate allows the assembly to be mounted in a panel of any thickness. Depth required 2-1/2″‘
A 72″ cables with female 0.250 disconnect crimp terminals.
Specifications:
-Working Voltage: DC 10-16 Volts +/- 10%
– Monitor trip voltage 12.0 volt +/- 10%, factory adjustable 10-14 volts contact us if you want a different voltage after you buy.
-Polarized male 0.250 stud disconnect crimp terminals.
– Alarm:
Piezoelectric 3900 +/- 500 Hz
Sound volume: 80 db
Sound type: intermittent one second on/off
LED Brightness:≥1500 mcd
Monitor position I monitoring only
Monitor position II monitoring and voltmeter on.
Center position off
